Airlink101 APO1010 - Manual (Page 20)

15
2.1.3 Hardware Installation Steps
Please follow the steps mentioned below to install the hardware of APO1000/APO1010:
¾ APO1000
Front Panel Rear Panel
Î Connect N-type antenna to the N-type connector on the rear panel.
Î Connect Power Injector to the PoE connector on the front panel.
Î Connect an Ethernet cable to the Power Injector and the other end to a computer.
Î Source power to Power Injector in order to supply power to APO1000.
¾ APO1010
Front Panel Rear Panel
Î Connect Power Injector to the PoE connector on the front panel.
Î Connect an Ethernet cable to the Power Injector and the other end to a computer.
Î Source power to Power Injector in order to supply power to APO1010.