2 configure lan ip – Airlink101 APO1010 User Manual
Page 59
54
4.1.2 Configure LAN IP
Here are the instructions for how to setup the local IP Address and Netmask.
Please click on System -> LAN and follow the below setting.
Î
Mode : Check either “Static IP” or “Dynamic IP” button as desired to set up the system IP of LAN port .
Î
Static IP : The administrator can manually setup the LAN IP address when static IP is available/ preferred.
9
IP Address : The IP address of the LAN port; default IP address is 192.168.10.100
9
IP Netmask : The Subnet mask of the LAN port; default Netmask is 255.255.255.0
9
IP Gateway : The default gateway of the LAN port; default Gateway is 192.168.10.1
Î
Dynamic IP : This configuration type is applicable when the APO1000/APO1010 is connected to a network with the
presence of a DHCP server; all related IP information will be provided by the DHCP server automatically.
Î
Hostname : The Hostname of the LAN port
DNS : Check either “No Default DNS Server” or “Specify DNS Server IP” button as desired to set up the system DNS.
Î
Primary : The IP address of the primary DNS server.
Î
Secondary : The IP address of the secondary DNS server.
Î
802.1d Spanning Tree
The spanning tree network protocol provides a loop free topology for a bridged LAN between LAN interface and 8 WDS
interfaces from wds0 to wds7. The Spanning Tree Protocol, which is also referred to as STP, is defined in the IEEE
Standard 802.1d.