4 configure lan ip – Airlink101 APO1010 User Manual
Page 90
85
5.1.4 Configure LAN IP
Here are the instructions for how to setup the local IP Address and Netmask.
Please click on System -> LAN and follow the below setting.
LAN IP : The administrator can manually setup the LAN IP address.
Î
IP Address : The IP address of the LAN port; default IP address is 192.168.10.100
Î
IP Netmask : The Subnet mask of the LAN port; default Netmask is 255.255.255.0
Î
802.1d Spanning Tree
The spanning tree network protocol provides a loop free topology for a bridged LAN between LAN interface. The
Spanning Tree Protocol, which is also referred to as STP, is defined in the IEEE Standard 802.1d.
DHCP Server : Devices connected to the system can obtain an IP address automatically when this service is enabled.
Î
DHCP : Check Enable button to activate this function or Disable to deactivate this service.
Î
Start IP / End IP: Specify the range of IP addresses to be used by the DHCP server when assigning IP address to
clients. The default range IP address is 192.168.10.101 to 192.168.10.254, the netmask is 255.255.255.0
Î
DNS1 IP : Enter IP address of the first DNS server; this field is required.