Flytec 4010 * - Manual (Page 11)

Operating Instructions FLYTEC 4010 10
Altimeter 2 setting mode
The altitude can be set in setting mode in precisely the same way as with altimeter 1.
If altimeter 2 is selected as the absolute altimeter, it is coupled to altimeter 1. Any change in
the display for altimeter 1 is reflected by a corresponding change in the display for altimeter 2
and vice-versa.
Altimeter 2 option mode
In option mode, you can select the unit (meters or feet) at the first level as with altimeter 1. The
unit selected flashes in the display. You can toggle between units by pressing either the key
or the key.
Press key to enter the second level of option mode. At this level, you select the operating
mode of altimeter 2. If this is set at absolute altimete, the two indicators ALT 1 and ALT 2 will
flash in the display. If set at relative altimeter, only the indicator ALT 2 will flash.
You return from option mode to run mode by waiting 15 seconds or again pressing the two
keys marked “OPTION” simultaneously.
CLEAR ALT 2
START - STOP
RESET
ALT 1
ALT 2
CHRONO