iPazzPort KP-810-19R/19VR - Manual (Page 11)

Setup
Battery Saver
Your remote automatically turns off if the buttons are depressed more
than 30 seconds. This will save your batteries should your remote get
stuck in a place where the buttons remain depressed (e.g., between
the sofa cushions).
Code Saver
Codes are stored in permanent memory while you are changing batteries
so you will not lose any codes stored in the remote while you are
changing batteries.
Power-On Default
The remote powers on in TV mode.
Code Setup
The SETUP button is used to setup the remote. You can either setup
the remote using the code for your brand of product, from the code
tables (on separate sheet), or you can search through the library of
codes until you find a code that works for your product.
Please refer to “Programming with Code Search” on page 9 for more
information on using the code search feature to learn how to search
through the library of codes for your products.
NOTE: You can store any kind of code under any mode (except TV). I.E.
you can store a VCR code under the CBL button, or a DVD code under
the VCR button, etc.However, you can only store TV codes under the
TV button.
Code Entry
Direct Code Entry
1. Press and hold the SETUP button until the red indicator stays on,
then release the SETUP button.
2. Press and release the desired mode button (TV,VCR, etc.). The red
indicator blinks, then stays lit.
3. Enter the 4 digit code from the code tables (on separate sheet).
Note: after a valid code entry, the red indicator turns off. For an
invalid code, the red indicator flashes.
4. With your device on, press CHANNEL UP. If the device responds,
no further programming is required.
Note: If some buttons do not operate your equipment,try one of the
other codes for your brand.