iPazzPort KP-810-19R/19VR - Manual (Page 14)

Controlling Combo Devices
Some Combo devices (e.g. TV/VCR, TV/DVD, DVD/VCR, etc.) have
separate buttons on the original remote to select the part of the Combo
device to be controlled.For example, if your Combo device is a DVD/VCR
then its original remote might have separate DVD and VCR buttons for
selection of the Combo part you would control. The equivalent button
functions can be found on your Philips remote by using the device
Mode and SETUP buttons.
Referring to “Programming with Code Search” on page 10, setup a
device Mode (e.g. DVD) with the correct code for your Combo device.
Assuming the DVD/VCR Combo device is the example and its code is
programmed under DVD Mode, press and hold the DVD Mode button
for more than one second to send the DVD button command. To send
the VCR button command, quickly press and release the SETUP button
followed by pressing and releasing the DVD Mode button. This method
can be applied similarly to all Combo devices (e.g. TV/VCR, TV/DVD,
DVD/VCR, etc.) and is available for all Modes. Note this feature is not
supported by all codes.
Controlling Devices Requiring Separate Power On and Off Buttons
Some devices (e.g. certain RCA TVs) require separate Power On and
Power Off buttons to turn the device on and off. The equivalent button
functions can be found on your Philips remote by using the device
Mode and POWER buttons. Referring to “Programming with Code
Search” on page 8, setup a device Mode (e.g. TV) with the correct code
for your device.
Assuming a TV device is the example and its code is programmed
under TV Mode, to turn your TV on, press and hold the TV Mode button
for more than one second to transmit the Power On button command.
To turn the TV off, press and release the POWER button to transmit the
Power Off button command. This method can be applied similarly to
any device and is available for all Modes. Note this feature is not
supported by all codes.