iPazzPort KP-810-19R/19VR - Manual (Page 13)

5. Press the CHANNEL UP button ((or POWER or PLAY (VCR only))
repeatedly until the device to be controlled changes channel. The red
indicator blinks off with each button press. If you accidentally overshoot
the code required, press the CHANNEL DOWN button to backtrack
through the library until the device changes channel. Pressing CHANNEL
UP changes direction to forward again.
6. Press and release MUTE to install the code.
Brand Search Method entry is now complete.
Note: When all codes under a Brand have been searched the red
indicator flashes rapidly for 3 seconds.
Code Identification Feature
The Code Identification Feature allows you to identify the 4 digit library
code stored under your device key. For example, if you want to find out
what 4 digit code is stored under your TV device key, follow the six steps
below:
1. Press and hold the SETUP button until the red indicator stays on.
Release the SETUP button.
2. Press and release the desired mode button (TV,VCR, etc.). The red
indicator blinks, then stays lit.
3. Press and release the SETUP button. The red indicator blinks off.
4. To find the first digit for the code stored under the mode key pressed
in step 2, press each numeric key from 0-9 in turn. When the red
indicator blinks off the number you pressed is the first digit for the
code you are searching for.
5. To find the second digit, repeat step 4, this time when the red indicator
blinks off this is the second digit.
6. Repeat step 4 to find the third and fourth digits.
Programming Combo Device Codes
Some Combo devices (e.g. TV/VCR, TV/DVD, DVD/VCR, etc.) will
require you to set up two different Mode buttons to control both parts
of the Combo device. For example, if you have a TV/DVD Combo, you
might need to set up one code under the TV button to control the TV part
AND a separate code (under any other Mode button) to control the DVD
part.