iPazzPort KP-810-19R/19VR - Manual (Page 16)

Setting ALL Volume/Mute Control to any one Mode
This routine can set all Modes to “punch-through” to any one chosen
Mode for Volume/Mute button control without the needing to change to
that Mode.
1. Press and hold the SETUP button until the red indicator turns on,
then release the button.
2. Press and hold the MUTE button until the red indicator blinks off,
then release the button.
3. Press and release the desired Mode button (TV,VCR, etc.) for
Volume/Mute control, the red indicator blinks then stays on.
4. Press and release the MUTE button and the red indicator turns off.
The red indicator will blink rapidly for three seconds if the Mode you
have selected has no Volume/Mute control.
5. All other Modes will now punch-through to your chosen Mode for
Volume/Mute control.
6. All “Visual” and “Audio” programmed Modes will now punch-through
to the respective Modes you have chosen for Volume/Mute control.
Setting any Mode to use its own Volume/Mute Control
This routine can set any Mode to use only its own Volume/Mute control.
Note - If your chosen Mode has no Volume/Mute functions of its own
then the Volume/Mute buttons will do nothing.
1. Press and hold the SETUP button until the red indicator turns on,
then release the button.
2. Press and hold the MUTE button until the red indicator blinks off,
then release the button.
3. Press and release the desired Mode button (TV,VCR, etc.), the red
indicator blinks then stays on.
4. Press and release the VOLUME- (Down) button, the red indicator
blinks then stays on.
5. Press and release the MUTE button and the red indicator turns off.
6. All “Visual” and “Audio” programmed Modes will now punch-through
to the respective Modes you have chosen for Volume/Mute control.