Campbell Scientific CR10X Measurement and Control System - Manual (Page 76)

SECTION 5. TELECOMMUNICATIONS
5-6
keyboard commands; it recognizes all the
standard CR10KD characters plus several
additional characters, including the decimal
point, the minus sign, and Enter (CR) (Section
OV3.2).
NOTE: Entering * 0 returns the CR10X to
the telecommunications command state.
Remember that entering * 0 will compile and
run the CR10X program if program changes
have been made.
The 7H Command is generally used with a
terminal for direct entry since H makes use of a
destructive backspace and does not send
control Q between each entry. The 2718H
Command functions the same as it does for
other Campbell Scientific dataloggers (deleting
an entry causes the entire entry to be sent,
"control Q" is sent after each user entry).
It is important to remember that the Remote
Keyboard State is still within
Telecommunications. Entering * 0 exits the
Remote Keyboard State and returns the
datalogger to the Telecommunications
Command State, awaiting another command.
The user can step back and forth between the
Telecommunications Command State and the
Remote Keyboard State.
7H (or 2718H)
Telecommunications Remote
Command Keyboard
State State
∗ 0