Campbell Scientific CSIOPC Software - Manual (Page 18)

CSIOPCServer
6.3.2.19 Line State
Type: enumeration
Applies to: All devices except BMP5 (PakBus) dataloggers
Description: The current line state for this device. The following values are
defined:
1. not-applicable — In its current configuration, this device will not
communicate directly with the server. This value will appear in
association with BMP1 dataloggers connected to the server through
an RF95T.
2. off-line — The server has no communication resources open for this
device.
3. on-line — The server has communication resources open for this
device.
4. transparent — This device has been dialed to reach a child device.
5. undialing — The child devices have gone off-line and this device is
cleaning up the link so that it can go to an off-line state.
6. comm-disabled — Communications are disabled for either this
device, its parent, or for the whole
7. network. unreachable — The device cannot be reached through the
network.
8. pending — The device has requested the link from its parent but that
request is still pending.
9. targeted — The device has requested the link from its parent and its
parents (and grandparents) are being dialed to open the link.
6.3.2.20 Polling Active
Type: bool
Applies to: All datalogger devices
Description: Reflects whether there is presently a polling operation that is
active for the device. A value of true will indicate that some sort of
polling is taking place.
6.3.2.21 FS1 to Collect
Type: uint4
Applies to: 21X, CR7X, CR10, CR10X, CR500, CR510, CR23X
12