Campbell Scientific LoggerNet-SDK Software Development Kit - Manual (Page 127)

Section 18. CsiDataSource Control Reference
COM Return Values
Table of Possible Values
Code Meaning
S_OK Success: Normal return.
E_CSI_BUSY Error: Cannot write to this property because
there is a connection to the LoggerNet server.
E_CSI_INVALIDARG Error: Value out of range.
DSource.state
Name
DSource.state As data_source_state
Description
This property describes the state of the control in regards to a connection with
the LoggerNet server. The following are the possible values of this property:
Table of Possible values.
Enumeration Name Value Description
dataSourceDisconnected 1 The control is currently disconnected and its read/write
properties are accessible
dataSourceConnecting 2 The connect method has been invoked and the control is
attempting to connect to the LoggerNet server.
Properties are read-only at this time
dataSourceConnected 3 The connect method has been successfully invoked and
the control has a connection to the server. It is
appropriate at this time to create advisors and start them.
COM Return Values
Table of Possible Values
Code Meaning
S_OK Success: Normal return.
DSource.sendRecordBlocks
Name
DSource.sendRecordBlocks As Boolean
Description
When set to TRUE, records will be sent back from LoggerNet to an Advisor in
blocks rather than one at a time. This is a more efficient method of receiving
records if a large number of records are being collected.
18-3