Campbell Scientific LoggerNet-SDK Software Development Kit - Manual (Page 130)

Section 18. CsiDataSource Control Reference
COM Return Values
Table of Possible Values
Code Meaning
S_OK Success: Normal return
DSource_onAdviseRecord()
Name
onAdviseRecord(Object myAdvisor, Object myRecord)
Description
This event returns notification of newly acquired data from an advisor. If
records are not being acquired, the advisor will not display them. Please make
sure the tables specified in the advisor are enabled for collection through the
use of CoraScript commands (set-collect-area-setting setting ID 2). Once the
tables are enabled for collection, use the Datalogger control to manually collect
records or use the CoraScript control to enable scheduled collection.
COM Return Values
Table of Possible Values
Code Meaning
S_OK Success: Normal return
DSource_onAdvisorFailure()
Name
onAdvisorFailure(csiAdvisorFailureCode failure,
Advisor myAdvisor)
Description
Indicates there was a failure with the advisor specified in myAdvisor.
Parameters
Table of Possible response codes.
Enumeration Name Value Description
csiAdvisorFailureUnknown 0 Indicates that an error has occurred but its
nature is unknown
csiAdvisorFailureConnectionFailed 1 Indicates that the connection failed. This can
happen if a connection has been successfully
established but then lost or because an invalid
serverName or serverPort property value was
specified. This type of failure can also occur if
the IP stack on the server host or on the host
for this application is not configured correctly.
18-6