Campbell Scientific RavenXTG Sierra Wireless Cellular Modem - Manual (Page 25)

RavenXTG GPRS/EDGE Sierra Wireless Cellular Modem
5. For PakBus dataloggers, set the PakBus address to match that of the
datalogger (default address in the datalogger is 1). Click the “Apply”
button to save the changes.
6.1 Test the Cellular Connection
After the Device Map has been configured, test the cellular connection using
the “Connect” screen as shown below. Click on the appropriate station, then
click the “Connect” button to initiate a call to the datalogger. If the call is
successful, the connectors at the bottom of the screen will come together, and
time information from the datalogger displayed will be the “Station
Date/Time” field. If the connection fails, a “Communications Failure”
message is displayed. Troubleshooting procedures can be found in Section 7,
Troubleshooting, and Appendix E, Troubleshooting Flowchart.
19