Campbell Scientific SC-USB USB to CS I/O Optically Isolated Interface - Manual (Page 26)

SC-USB USB to CS I/O Opto-isolated Interface
3.1.4 Windows 98/98SE/ME
Use the USB cable to connect your SC-USB device to the PC’s USB port. The
first time that this is done, the ‘Building Driver Information Database’ screen
followed by the ‘Add New Hardware Wizard’ screen will normally be
displayed, as shown below. (If it is not displayed immediately, try rebooting
the PC with the SC-USB plugged in or run the Add New Hardware option in
the Control Panel.)
Press ‘Next’ and you will see the following screen.
20