Samsung SGH-T539ABBTMB - Manual (Page 92)

89
Voice commands
Voice Commands is an advanced speech recognition software used to activate a
wide-variety of functions on your phone. Voice Commands software automatically
voice activates (up to 200 contacts) for voice dialing and searching. No
pre-recording or training needed. Speak a contact name naturally to dial, and use
your voice to look up contacts, launch applications and navigate phone menus.
1. In Idle mode, press the Menu soft key to access Menu mode.
2. Select Fun & Apps and press the Select soft key or the
key.
3. Highlight Voice commands and press the Select soft key or the key.
4. At the voice prompt, say a command. The list of available commands is
listed below.
Note: This list of voice commands is briefly displayed.
Voice Recognition Commands
• Call <Name> : dials a name from your contact list. For more information, refer to
"Contacts List Voice Activation" on page 90.
• Send Text <Name> : displays the Create Text Message screen. For more
information, refer to "Create new Text Message" on page 64.
• Lookup <Name> : allows you use a voice command to locate and display contact
information stored in the Contacts list. For more information, refer to "Contact
List" on page 54.
• Go to <App> : accesses all the features of your phone if they are activated, such
as: Phonebook, Music player, t-zones, Messages, or Organizer. For more
information, refer to "Active menus" on page 97.
• Check <Item> : lets you check your phone's status in the same report (that is,
battery charge, signal strength, and my phone number listing).
Speak clearly when giving your command. There is no need for you to speak slowly
or with added emphasis. The voice recognition software has been optimized to
understand your speech in its natural form. If it does not recognize your command
after a few seconds, a voice prompt asks you to repeat the command. IIf it does not
recognize your command again, the following message displays "Sorry, no match
found," and voice recognition turns off.
Important!: You must end your current Voice Commands call before you can make another call.