Samsung LTP468WX-XAA - Manual (Page 27)

25
Connection & Input Source Setup
Connecting VHF and UHF Antennas
Connecting VHF and UHF Antennas
If your antenna has a set of leads that look like this, see “Antennas with
300-ohm Flat Twin Leads” below.
If your antenna has one lead that looks like this, see “Antennas with 75-
ohm Round Leads” on next page.
If you have two antennas, see “Separate VHF and UHF Antennas” on next
page.
If you are using an off-air antenna (such as a roof antenna or “rabbit ears”) that has 300-ohm twin flat leads, follow
the directions below.
Antennas with 300-ohm Flat Twin Leads
1
Place the wires from the twin leads under the screws on
the 300-75 ohm adaptor (not supplied). Use a screwdriver
to tighten the screws.
If you are using an off-air antenna (such as a roof antenna or “rabbit ears”) that has 300-ohm twin flat leads, follow
the directions below.
Antennas with 75-ohm Round Leads
Plug the antenna lead into the VHF/UHF terminal on the
bottom of the back panel.
2 Plug the adaptor into the VHF/UHF terminal on the bottom
of the back panel.
BN68-00665D-01_22~51 9/1/04 2:34 AM Page 25