Apple FireWire Cable - Manual (Page 4)

Xserve FireWire Cable - 4
Removing the Installed FireWire Cable
1. Disconnect the FireWire cable from the front panel board. (Figure 3)
2. Disconnect the FireWire cable from the drive interconnect board and remove the cable
from the server.
Figure 3
Installing the Replacement FireWire Cable
Connect the replacement FireWire cable to the drive interconnect board and the front
panel board.
Closing the Server
1. Carefully slide the bottom housing back into the rack.
2. Tighten the front thumb screws to secure it.
Warning: Never turn on the server unless all of its internal and external parts
are in place and it is closed. Operating the server when it is open or missing
parts can damage it or cause injury.