Adaptec Ultra Wireless WirelessTM USB Adapter User Manual
Page 35
28
Adaptec Ultra Wireless USB Adapter User’s Guide
To link your Wireless USB Adapter to your WLAN:
1
Open the Adaptec Wireless Utility by double-clicking the
Adaptec Wireless Utility
icon on your taskbar.
2
Click the Configuration tab.
a
Ensure that the Operating Mode setting is correct for your
WLAN. Each station on your WLAN must be set to the same
operating mode. (See
Changing the Operating Mode on
for more information.)
b
Check that the Wireless Network ID (SSID) is the same as the
one used on your other WLAN stations.
You can also set your Wireless Network ID to the word
any
,
which allows your Wireless USB Adapter to connect to any
Wireless device on your WLAN.
Note:
Ensure that Access Points on your WLAN allow
connections from Wireless devices set to
any
before
using this setting.
c
If you are using Ad-hoc mode, check that the Channel
number is the same number used on your other WLAN
station. If you are using Infrastructure mode, the Channel
number is set by your Access Point (AP). (See channel on
for more information.)
d
Make any necessary changes, then click Apply Changes.
Double-click