Document Outline

• Contents
• Figures
• Preface
  • Safety Symbols Used in this Document
  • Where to Find Web-based Guides
  • Contacting Allied Telesis
    • Online Support
    • Email and Telephone Support
    • Warranty
    • Returning Products
    • Sales or Corporate Information
    • Management Software Updates
• Chapter 1
  • Introduction to the AT-29xx Series Gigabit Ethernet Network Adapters
    • Functional Description
      • Contents of Your Shipment
    • LEDs
    • AT-29xx Series Adapter Software Drivers
      • Supported Operating Systems
      • Software Driver Features
    • Failover Teaming
• Chapter 2
  • Installing the Hardware
    • Reviewing Safety Precautions
    • Pre-Installation Checklist
    • Installing a Network Adapter Card
    • Connecting the Network Cables
    • Warranty Registration
• Chapter 3
  • Installing Windows Server 2003 and Windows XP Driver Software
    • Installing the Driver Software
      • Using the Driver Installer
      • Updating the Adapter Software
      • Modifying Configuration Properties
    • Uninstalling the Driver Software
• Chapter 4
  • Installing the Windows 2008 R2, Windows Vista, and Windows 7 Driver Software
    • Installing the Driver Software
      • Selecting the Device Manager
      • Installing the Windows 2008 R2, Windows, Vista, and Windows 7 Driver Software
    • Uninstalling the Driver Software
• Chapter 5
  • Setting Advanced Properties
    • Opening Advanced Properties
      • 802.1p QOS
      • Ethernet@Wirespeed™ (AT-2972/T2 only)
      • Flow Control
      • Jumbo Mtu
      • Interrupt Moderation
      • IPSec Offload
      • Large Send Offload Property
      • Network Address
      • Priority & VLAN
      • Receive Side Scaling
      • Speed & Duplex Mode
      • Checksum Offload
      • VLAN ID
      • Wake Up Capabilities
      • WOL Speed
• Chapter 6
  • Installing the Linux Driver Software
    • Installing the Linux Driver Software
      • Building a Driver from a TAR File
    • Network Installation
    • Removing the Linux Driver from a TAR Installation
    • Module Parameters
• Chapter 7
  • Installing the Novell NetWare Driver Software
    • Driver Installation
    • Pre-Installation Requirements
    • Installing Novell NetWare Server 5.x or 6.0 Driver Software
    • Verifying or Modifying Adapter Parameters
    • Removing Drivers from Autoexec.ncf
• Chapter 8
  • Installing the NDIS2 Driver Software for MS-DOS Platforms
    • Installing the NDIS2 Driver Software for Use on MS-DOS Platforms
      • Pre-Installation Requirements
      • Modifying the Startup Disk
    • Using Keywords for the B57.dos Drivers
• Chapter 9
  • Installing the PXE Boot Agent
    • Overview
      • Setup BIOS
    • Server Setup
      • Windows Server 2003 and Windows XP
      • DOS UNDI/ APITEST
      • Red Hat Linux
• Chapter 10
  • Troubleshooting
    • Hardware Diagnostics
    • Checking Port LEDs on the Adapter
    • Troubleshooting Checklist
    • Verifying the Correct Drivers are Loaded
      • NetWare
      • Linux
    • Testing Network Connectivity
      • Windows Server 2003
      • NetWare
      • Linux
    • Software Problems and Solutions
      • Microsoft Remote Installation Service (RIS) Instructions
      • Windows Server 2003
      • Miscellaneous
• Chapter 11
  • DOS Diagnostics
    • Introduction
    • DOS Prompt Commands
    • Diagnostic Tests
      • Test Names
      • Test Descriptions
    • Error Messages
• Appendix A
  • Specifications
    • Physical Specifications
    • Environmental Specifications
    • Power Specifications
    • Performance Specifications
    • Operating Specifications
• Appendix B
  • Cleaning Fiber Optic Connectors
    • Using a Cartridge-Type Cleaner
    • Using a Swab