Allied Telesis AT-S95 CLI - Manual (Page 146)

Page 146
Allied Telesis
AT-S95 Management Software CLI User’s Guide
Parameters
•
ipv6-address — The IPv6 network assigned to the interface. The address is specified in hexadecimal using
16-bit values between colons.
• prefix-length — The length of the IPv6 prefix. A decimal value that indicates how many of the high-order
contiguous bits of the address comprise the prefix (the network portion of the address). A slash mark must
precede the decimal. (Range: 3-128. 64 when the eui-64 parameter is used.)
• eui-64 — Specifies to build an interface ID in the low-order 64 bits of the IPv6 address, based on the interface
MAC address.
• anycast — Defines the IPv6 address as an anycast address.
Default Configuration
No IPV6 address is defined for the interface.
Command Mode
Interface Configuration (VLAN 1 only) mode.
User Guidelines
•
If the value specified for the /prefix-length argument is greater than 64 bits, the prefix bits have precedence
over the interface ID.
• Using the no ipv6 address command without arguments removes all manually configured IPv6 addresses
from an interface, including link-local manually configured addresses.
Example
The following example configures an IPv6 address FE80::260:3EFF:FE11:6770 for interface e1.
ipv6 address link-local
The ipv6 address link-local Interface Configuration mode command configures an IPv6 link-local address for an
interface. Use the no form of this command to return to the default link-local address on the interface.
Syntax
ipv6 address ipv6-address link-local
no ipv6 address ipv6-address link-local
Parameters
•
ipv6-address — The IPv6 network address assigned to the interface. The address is specified in hexadecimal
using 16-bit values between colons.
Default Configuration
IPv6 is enabled on the interface. Link local address of the interface is FE80::EUI64 (interface MAC address).
Command Mode
Interface configuration (VLAN 1 only).
console(config)# interface e1
console(config-if)# ipv6 address FE80::260:3EFF:FE11:6770