Allied Telesis AT-S95 CLI - Manual (Page 211)

QoS Commands
Page 211
Parameters
•
rate — Maximum kilobits per second of ingress traffic on a port. (Range: 3500 - 1000000).
Default Configuration
1000 Kbits/Sec
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
The command can be enabled on a specific port only if port storm-control Broadcast enable interface
configuration command is not enabled on that port.
Example
The following example limits the rate of the incoming traffic to 62.
traffic-shape
The traffic-shape Interface Configuration mode command sets a shaper on an egress interface. Use the no form
of this command to disable the shaper.
Syntax
traffic-shape committed-rate
no traffic-shape
Parameters
•
committed-rate — The average traffic rate (CIR) in bits per second (bps). (Range: 64 -10000.)
Default Configuration
No shape is defined.
Command Mode
Interface Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures a shaper on port e1.
Console(config-if)# rate-limit 62
console(config-if)# traffic-shape 50000