Allied Telesis AT-S95 CLI - Manual (Page 325)

System Management Commands
Page 325
Example
The following example lists open Telnet sessions.
The following table describes significant fields shown above.
show system
The show system User EXEC mode command displays system information.
Syntax
show system [unit unit]
Parameters
•
unit— Specifies the number of the unit. (Range: 1 - 6)
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode
User Guidelines
There are no user guidelines for this command.
console> show sessions
Connection Host Address Port Byte
---------- ------------- ---------- ----- ----
1 Remote device 172.16.1.1 23 89
2 172.16.1.2 172.16.1.2 23 8
Field Description
Connection Connection number.
Host Remote host to which the device is connected through a Telnet session.
Address IP address of the remote host.
Port Telnet TCP port number
Byte Number of unread bytes for the user to see on the connection.