Allied Telesis AT-S95 CLI - Manual (Page 164)

Page 164
Allied Telesis
AT-S95 Management Software CLI User’s Guide
Chapter 15.LACP Commands
lacp system-priority
The lacp system-priority Global Configuration mode command configures the system priority. Use the no form
of this command to return to the default configuration.
Syntax
lacp system-priority value
no lacp system-priority
Parameters
•
value — Specifies system priority value. (Range: 1 - 65535)
Default Configuration
The default system priority is 1.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures the system priority to 120.
console(config)# lacp system-priority 120