Allied Telesis AT-PWR3101 User Manual
Page 24
Advertising
Installation Instructions
24
5. Plug one end of a 17-pin D-combo connector RPS cable into the
connector labeled “RPS INPUT” on the rear panel of the
AT-8524POE switch (see Figure 11).
Figure 11. Connecting the RPS Cable to the Switch
6. Tighten the thumb screws on the connector to secure the cable to the
switch (see Figure 12).
Figure 12. Securing the RPS Cable to the Switch
RPS INPU
T
RPS INPUT
Advertising
This manual is related to the following products: