Allied Telesis AT-PWR3101 - Manual (Page 26)

Installation Instructions
26
9. Turn the On/Off switch for Slot A on the back panel of the
AT-RPS3104 system to the On position (see Figure 8 on page 22).
10. Check the STATUS LED on the front panel of the AT-PWR3101
module. It should be green. If the LED is off, repeat this procedure to
ensure that all cables are securely connected to the unit. If the LED is
amber, the module has experienced a problem. Contact your local
Allied Telesyn sales representative or Allied Telesyn technical
support for assistance.
11. Check the RPS LED on the front of the AT-8524POE switch. It should
be green. If it is off, repeat this procedure to ensure that all cables are
securely connected to the switch and the RPS unit.
Note
The RPS LED on the switch is green whenever the unit detects that
an RPS unit is connected to it, even when the RPS unit is powered
off.
The installation is complete.