Allied Telesis AT-S99 - Manual (Page 153)

AT-S73 and AT-S99 Management Software User’s Guide
153
Restoring the Default Settings
The procedures in this section are used to restore the default settings on
the AT-CM Line Cards.
Caution
These procedures are disruptive to network operations. Some
network traffic may be lost. A line card whose current operating
mode is not the OAM visible mode has to initialize its management
software after restoring the default values. Although the card
immediately resumes forwarding network traffic, it will be
unresponsive to management commands for one minute during the
initialization process.
These procedures are not supported on the AT-CM70S Line Card or the
AT-CV Line Cards.
Menus
To return the parameter settings of the AT-CM Line Cards to the default
settings from the menus:
1. From the Main Menu, select Module Status and Configuration to
display the Module Status and Configuration menu shown in Figure 48
on page 128.
2. From the Module Status and Configuration menu, select the AT-CM
Line Card you want to return to the default settings. You can configure
only one line card at a time. The Module Configuration Menu in Figure
53 on page 139 is displayed.
3. Select Line Card Configuration to display the Line Card
Configuration Menu in Figure 62.
Figure 62. Line Card Configuration Menu
Line Card Configuration
Auto-copy Line Card Configuration
Display Current Configuration
Display Last saved Configuration
Display Default Configuration
Restore Last Saved Configuration
Return Line Card to Default Configuration
Save Line Card Configuration
Return to Module Configuration Menu ...