Allied Telesis AT-S99 - Manual (Page 181)

AT-S73 and AT-S99 Management Software User’s Guide
181
Restoring the
Last Saved
Configuration
This procedure restores a remote line card to the last saved configuration
in the master configuration file on the management card in the local
chassis. You might perform this procedure to discard any parameter
changes that you made to a line card but did not saved, or to configure a
new line card with the save settings as its predecessor. For more
information, refer to “Configuration Files” on page 29.
Caution
This procedure may disrupt network operations. Some traffic may be
lost.
1. From the Remote Module Configuration Menu, select Line Card
Configuration.
2. To view the parameter settings of the card’s last saved configuration
before activating them on the line card, select Display Last Saved
Configuration.
3. To return the line card to its last saved configuration, return to the Line
Card Configuration menu and select Restore Last Saved
Configuration.
4. At the confirmation prompt, select Yes to restore the settings or No to
cancel the procedure.
Saving the
Parameter
Settings
Your changes to the parameter settings on remote AT-CM Line Cards are
automatically saved in the configuration files in flash memory and are
retained even if the remote chassis is powered off or the cards are
removed.
If desired, you can add the configuration settings of remote line cards to
the master configuration file in the management card in the local chassis
so that you can restore them to the remote cards, should that ever be
necessary. To save the settings in the master configuration file, select
Line Card Configuration and Save Line Card Configuration. If you ever
need to restore the setting to the line card, perform “Restoring the Last
Saved Configuration” on page 181.