Allied Telesis AT-S97 - Manual (Page 113)

113
Chapter 7
Network Time Protocol Commands
This chapter describes how to set the internal clock and calender from an
NTP server on your network or the Internet. This chapter contains the
following sections:
ˆ “Overview” on page 114
ˆ “NTP DISABLE” on page 116
ˆ “NTP ENABLE” on page 117
ˆ “NTP SET” on page 118
ˆ “NTP SHOW” on page 119
Note
Remember to save your parameters changes in the active master
configuration file with the CONFIG SAVE command. For information,
refer to “Saving Your Configuration Changes” on page 17 or Chapter
9, “Configuration File Commands” on page 141.