Allied Telesis AT-S97 - Manual (Page 47)

47
Chapter 4
IP Configuration Commands
This chapter describes how to assign an IP address to the AT-MCF2000M
Management Module. This chapter contains the following sections:
ˆ “Overview” on page 48
ˆ “IP DHCP DISABLE” on page 50
ˆ “IP DHCP ENABLE” on page 51
ˆ “IP SET” on page 52
ˆ “IP SHOW” on page 54
Note
Remember to save your parameters changes in the active master
configuration file with the CONFIG SAVE command. For information,
refer to “Saving Your Configuration Changes” on page 17 or Chapter
9, “Configuration File Commands” on page 141.