Allied Telesis AT-S97 - Manual (Page 201)

201
Chapter 12
Simple Network Management Protocol
(SNMP) Commands
This chapter describes the commands that permit you to manage the
media converter using the SNMPv1 and SNMPv2c protocols. This chapter
contains the following sections:
ˆ “Overview” on page 202
ˆ “SNMP SET” on page 205
ˆ “SNMP SHOW” on page 207
Note
Remember to save your parameters changes in the active master
configuration file with the CONFIG SAVE command. For information,
refer to “Saving Your Configuration Changes” on page 17 or
“CONFIG SAVE” on page 157.