Allied Telesis AT-S70 - Manual (Page 73)

AT-S70 Management Software User’s Guide
73
Port
Identifies the ports of the module.
Link
Displays the status of the link state on the ports.
ˆ Online - Indicates that there is a valid link.
ˆ Offline - Indicates that there is no link.
Speed
Displays the operating speed of the ports. Possible values are:
ˆ Fiber port (Port A) - 10M or 100M
ˆ Copper port (Port B) - Auto, 10M, or 100M
Mode
Displays the duplex mode of the ports. Possible values are:
ˆ Auto - The port is auto-negotiating with the connected device to
automatically configure to the highest common setting.
ˆ Full - The module can send and receive data simultaneously.
ˆ Half - The module can send or receive data, but not both at the
same time.
Configure Operating Mode
Configures the operating mode of a line card. For more information, go
to “Configuring the Line Card Operating Mode” on page 67.
Display DIP Switch Setting
Displays the setting of the DIP switch on the line card selected, refer to
“Displaying Line Card DIP Switch Settings” on page 56.
TDM LIU (T1/E1) Configuration
Displays the current TDM (Time-division multiplexing) LIU (line
interface unit) configuration of the T1/E1 port on the line card. For
more information on this configuration, refer to “Configuring the AT-
CM70S TDM Port” on page 75.
4. From the Main Menu, select System Configuration.
The System Configuration Menu is displayed, as shown in Figure 10
on page 46.
5. From the System Configuration Menu, select Save Configuration
File.