Allied Telesis AT-S62 - Manual (Page 256)

Chapter 14: Event Log and Syslog Server Commands
256 Section II: Advanced Operations
An example of the information displayed by this command with the FULL
parameter is shown in Figure 25.
Figure 25. SHOW LOG OUTPUT Command with the FULL Parameter
For definitions of the parameters, refer to “SET LOG OUTPUT” on
page 247.
Examples
The following command lists all the output definitions:
show log output
The following command displays the details of output definition number 5:
show log output=5 full
Output ID .................... 2
Output Type .................. Syslog
Status ....................... Enabled
Server IP Address ............ 149.88.88.88
Message Format ............... Extended
Facility Level ............... DEFAULT
Event Severity ............... E,W,I
Event Module ................. All