Allied Telesis AT-S62 - Manual (Page 341)

AT-S62 Management Software Command Line Interface User’s Guide
Section II: Advanced Operations 341
SHOW IGMPSNOOPING
Syntax
show igmpsnooping
Parameters
None.
Description
This command displays the IGMP parameters. Figure 33 illustrates the
information that is displayed by this command.
Figure 33. SHOW IGMPSNOOPING Command
For an explanation of these parameters, refer to “SET IP IGMP” on
page 338.
Examples
The following command displays the current IGMP parameter settings:
show igmpsnooping
Equivalent Command
show ip igmp
For information, see “SHOW IP IGMP” on page 342.
IGMP Information:
IGMP Snooping Status ............... Disabled
Multicast Host Topology ............ Single-Host/Port (Edge)
Host/Router Timeout Interval ....... 260 seconds
Maximum Multicast Groups ........... 64
Multicast Router Port(s) ........... Auto Detect