Allied Telesis AT-S70 - Manual (Page 16)

Chapter 1: Overview
16
Local Management Session
You establish a local management session with a Converteon chassis by
connecting a terminal or a PC with a terminal emulator program to the RS-
232 Terminal Port on the CPM card installed in the front of the chassis,
using the straight-through RS-232 management cable. This type of
management session is referred to as “local” because you must be
physically close to the chassis, such as in the wiring closet where the
chassis is located.
After the session starts, a menu is displayed from which you can make
selections to configure and monitor the chassis. You can configure all
operating parameters of a chassis from a local management session.
Note
For instructions on starting a local management session, refer to
“Starting a Local Management Session” on page 21.
A chassis does not need an Internet Protocol (IP) address for you to
manage it locally. You can start a local management session on a chassis
at any time. It will not affect the forwarding of frames by the device.