Allied Telesis AT-S70 - Manual (Page 48)

Chapter 4: Basic Parameters
48
Setting the RS-232 Terminal Baud Rate
The default settings for the RS-232 port are:
ˆ Bits per second: 1200 bps to 115200bps
ˆ Data bits: 8
ˆ Parity: None
ˆ Stop bits: 1
ˆ Flow control: None
To set the RS-232 port to a different baud rate, perform the following
procedure:
1. From the Main Menu, select System Configuration.
The System Configuration Menu, as shown in Figure 5 on page 35, is
displayed.
2. From the System Configuration Menu, select Terminal
Configuration.
The Terminal Configuration Menu, as shown in Figure 14, is displayed.
Figure 14. Terminal Configuration Menu
3. From the Terminal Configuration Menu, select Data rate (baud rate).
Terminal Configuration Menu
Converteon
Data rate (baud rate) ...
Return to System Configuration Menu...