Allied Telesis AT-WL2411 User Manual
Page 116

AT-WL2411 Installation and User’s Guide
116
2. Click Wireless Bridging. The Wireless Bridging screen appears, as
shown in Figure 49.
Figure 49 Wireless Bridging Screen - Master
3. Click the down arrow on the right side of the Node Type field and
choose Master and then click Submit Changes. Your changes are
saved and the Wireless Hops parameter appears.
4. Click the down arrow on the right side of the Wireless Hops field and
choose Enabled and then click Submit Changes. Your changes are
saved and the Hello Period parameter appears.
5. Click the down arrow on the right side of the Hello Period field and
choose a hello period of 1, 2, or 3 seconds.
6. Click Submit Changes to save your changes. To activate your changes,
click the Save/Discard Changes link in the menu bar and then click
Save Changes and Reboot. For help, see Saving Your Configuration
Changes on page 46.
To configure the station radio (in the WAP):
1. From the main menu, click the link corresponding to the radio that
you are configuring.