Warranty registration, Troubleshooting, Is the switch receiving power – Allied Telesis AT-FS203 User Manual
Page 30: Port 2 port 1, Figure 13 mdi/mdi-x switch, Verify that the power led is lit, Installing the switch 20, Mdi mdi-x mdi mdi-x
Installing the Switch
20
Figure 13 MDI/MDI-X Switch
Warranty Registration
When you finish the installation, register your product by completing the
enclosed warranty card and sending it in, or by visiting our web site at
www.alliedtelesyn.com/forms/warranty.htm and completing the on-line
registration.
Troubleshooting
This section contains guidelines for troubleshooting the unit should a problem
occur.
Note
Whenever the speed and/or duplex mode are changed during or after
power ON, power OFF then power back on the switch to load the new
configuration.
Is the Switch Receiving Power?
❑
Verify that the Power LED is lit.
❑
If the Power LED is not ON, check the AC power adapter to verify that
the adapter is plugged into a functioning wall outlet and that the DC
power cord is properly inserted into the switch’s power connector.
10Base T/
100Base-TX
10Base-T/
100Base-TX
MDI
MDI-X MDI
MDI-X
PORT 2
PORT 1
10Base-T/
100Base-TX
AUTO NEG
10Base-T/
100Base-TX
MDI
MDI-X
FS203 FAST ETHERNET SWITCH
IEEE 802.3 / 802.3U
AUTO NEG
TX
RX
COL
LNK
PWR
100
FD
MDI
MDI-X
TX
RX
COL
LNK
100
FD
PORT 2
PORT 1