Allied Telesis AT-S25 - Manual (Page 202)

Section III: Web Browser Management
202
Configuring the SNMP Parameters and Trap IP Addresses
To change the switch’s SNMP community strings or to specify the IP
addresses of management stations to receive traps from the switch,
perform the following procedure:
1. From the Home page, select Configuration.
The Configuration window is displayed with the System menu
option selected by default.
2. If the System menu option is not selected, select it and then select the
SNMP tab.
The SNMP window in Figure 78 is displayed.
Figure 78 Configuration - SNMP Window
3. Enter or modify the parameters as desired.
To change a value, type its corresponding number and, when
prompted, enter the new value.
❑ To set a switch’s SNMP community strings, use the parameters
described below:
Š GET Community
Š SET Community
Š TRAP Community