Allied Telesis AT-8550 - Manual (Page 185)

AT-9108, AT-8518, AT-8525, and AT-8550 User’s Guide
10-5
Table 10-1 describes the commands used to configure IP multicast
routing.
Table 10-1 IP Multicast Routing Configuration Commands
Command Description
enable dvmrp Enables DVMRP on the system. The default setting
is disabled.
enable ipmcforwarding {<vlan <name} Enables IP multicast forwarding on an IP interface.
If no options are specified, all configured IP
interfaces are affected. When new IP interfaces are
added,
ipmcforwarding is disabled by default.
enable pim-dm Enables PIM-DM on the system. The default setting
is disabled.
config dvmrp add vlan [<name> | all] Enables DVMRP one or all IP interfaces. If no VLAN
is specified, DVMRP is enabled on all IP interfaces.
When an IP interface is created, DVMRP is disabled
by default.
config dvmrp delete vlan [<name> | all] Disables DVMRP on one or all IP interfaces. If no
VLAN is specified, DVMRP is disabled on all IP
interfaces.
config dvmrp vlan <name> timer
<probe_interval>
<neighbor_timeout_interval> Configures DVMRP interface timers. Specify the
following:
❑
probe_interval — The amount of time
that the system waits between transmitting
DVMRP probe messages. The range is 1 to
2,147,483,647 seconds (68 years). The default
setting is 10 seconds.
❑
neighbor_timeout_interval — The
amount of time before a DVMRP neighbor
route is declared to be down. The range is 1 to
2,147,483,647 seconds (68 years). The default
setting is 35 seconds.