Allied Telesis AT-8550 - Manual (Page 43)

AT-9108, AT-8518, AT-8525, and AT-8550 User’s Guide
2-19
IP Host Configuration Commands
Table 2-5 describes the commands that are used to configure IP
settings on the switch.
Table 2-5 IP Host Configuration Commands
Command Description
config iparp add <ipaddress>
<mac_address> Adds a permanent entry to the Address Resolution
Protocol (ARP) table. Specify the IP address and
MAC address of the entry.
config iparp delete <ipaddress> Deletes an entry from the ARP table. Specify the IP
address of the entry.
clear iparp {<ipaddress> | vlan <name>} Removes dynamic entries in the IP ARP table.
Permanent IP ARP entries are not affected.
config iproute add <ipaddress> <mask>
<gateway> {<metric>} Adds a static address to the routing table. Use a
value of 255.255.255.255 for
mask to indicate a host
entry.
config iproute delete <ipaddress>
<mask> <gateway> Deletes a static address from the routing table.
config iproute add default <gateway>
{<metric>} Adds a default gateway to the routing table. A
default gateway must be located on a configured IP
interface. If no metric is specified, the default metric
of 1 is used.
config iproute delete default <gateway> Deletes a default gateway from the routing table.
show ipconfig {vlan <name>} Displays configuration information for one or all
VLANs.
show ipstats {vlan <name>} Displays IP statistics for the CPU of the switch or for
a particular VLAN.
show iproute {priority | vlan <name> |
permanent | <ipaddress> <mask>} Displays the contents of the IP routing table.
show iparp {<ipaddress | vlan <name> |
permanent} Displays the IP ARP table. You can filter the display
by IP address, VLAN, or permanent entries.