Allied Telesis AT-8550 User Manual
Page 202
IPX Commands
11-10
describes the commands used to configure the IPX route
table.
Table 11-4 IPX/RIP Configuration Commands
Command
Description
enable ipxrip
Enables IPX/RIP on the router.
config ipxrip add vlan [<name> | all}
Configures one or all IPX VLANs to run IPX/RIP.
IPX/RIP is enabled by default when you configure
the IPX VLAN.
config ipxrip delete vlan [<name> | all]
Disables IPX/RIP on one or all interfaces.
config ipxrip {vlan <name> | all} max-
packet-size <number>
Configures the maximum transmission unit (MTU)
size of the IPX/RIP packet. the default setting is
432 bytes.
config ipxrip vlan [<name> | all] update-
interval <time> {hold-multiplier
<number>}
Configures the update interval and hold multiplier
for IPX/RIP updates. This setting affects both the
periodic update interval of IPX/RIP and the aging
interval of learned routes. The default update
interval is 60 seconds. The aging period is
calculated using the formula (update-interval x
multiplier). The default multiplier is 3.
config ipxrip vlan [<name> | all] delay
<msec>
Configures the time between each IPX/RIP packet
within an update interval. The default setting is 55
milliseconds.