Allied Telesis AT-8550 - Manual (Page 52)

Using SNMP
2-28
Displaying
SNMP Settings
To display the SNMP settings configured on the switch, enter the
following command:
show management
This command displays the following information:
❑ Enable/disable state for Telnet, SNMP, and Web access
❑ SNMP community strings
❑ Authorized SNMP station list
❑ SNMP trap receiver list
❑ RMON polling configuration
❑ Login statistics
config snmp delete [<ipaddress>
{<mask>} | all] Deletes the IP address of a specified SNMP
management station or all SNMP management
stations. If you delete all addresses, any machine
can have SNMP management access to the switch.
config snmp delete trapreceiver
[<ip_address> community <string> | all] Deletes the IP address of a specified trap receiver or
all authorized trap receivers.
config snmp syscontact <string> Configures the name of the system contact. A
maximum of 255 characters is allowed.
config snmp sysname <string> Configures the name of the switch. A maximum of
32 characters is allowed. The default sysname is the
model name of the device (for example,
Summit1) . The sysname appears in the switch
prompt.
config snmp syslocation <string> Configures the location of the switch. A maximum
of 255 characters is allowed.
Table 2-9 SNMP Configuration Commands (Continued)
Command Description