Allied Telesis AT-8324 - Manual (Page 53)

AT-8316F and AT-8324 Installation Guide
53
6. Remove the blank panel from the back of the switch selected to
be the master switch by unscrewing the two captive screws. Refer
to Figure 3-10.
Figure 3-10 Removing the Blank Panel from an Ethernet Switch
7. Remove the AT-Stack8 module from its shipping package and
store the packaging material in a safe location.
8. Slide the AT-Stack8 module into the expansion slot making sure
that the board is aligned properly with the card guides. Slide the
board into the switch until it snaps into place. Refer to Figure 3-11.
Figure 3-11 Installing the AT-Stack8 Module
9. Secure the AT-Stack8 module by tightening the two captive
screws.
10. Connect one end of an AT-CABLE-4 cable to Port 1 on the
AT-Stack8 module and the other end to Port IS-A on the master
switch. Refer to Figure 3-12.
IS-A
IS-B
STACK ID
Captive screw
Captive screw
AT-STA CK8
STACK PORT S
1
6
2
7
3
8
4
IS-A
5
IS-B
STACK ID
Captive screws
Card Guide