Allied Telesis AT-S39 - Manual (Page 126)

Chapter 13: VLAN Commands
126
SET SWITCH VLANSTATUS
Syntax
set switch vlanstatus=enabled|disabled
Parameters
vlanstatus Specifies the switch’s VLAN mode. Specifying
ENABLED means the switch will support tagged and
untagged VLANs. Specifying DISABLED means the
switch will support the Basic VLAN mode. The default
is tagged and untagged VLANs. Only one mode can be
active on a switch at a time.
Description
This command configures a switch to support either port-based and
tagged VLANs or the Basic VLAN mode.
Note
This command performs exactly the same function as the SET
SWITCH VLANMODE command.
Example
The following command configures the switch to support the Basic
VLAN mode:
set switch vlanstatus=disabled