PerTronix JBA Exhaust 40-2537 - Manual (Page 4)

15. Manipulate the tailpipes and mufflers so that they are level from the passenger side of the truck. When you
are satisfied with the position tighten all the clamps, making sure that the tips stay aligned as you do.
16. Clean the tips of any dirt or fingerprints before starting the truck.
17. Start the truck and listen fro leaks, tighten as necessary.
18. After 100 miles recheck all fasteners. It is recommended that you have all slip connections tack welded to
ensure they do not come loose.
LIMITED ONE YEAR WARRANTY
All JBA HEADERS and exhaust products are guaranteed, to the original purchas-
er, to be free of defects in materials and workmanship for one year. This warranty
covers the replacement or repair of the product only and does not cover the cost
of removal and installation, customer applied aftermarket coatings or any discolor-
ation or corrosion of finished surfaces.
Damage or product failure resulting from collision, improper installation, off-road
use, road hazards, the use of exhaust insulating wrap or like products or rust oc-
curring after installation, is not covered by the warranty. The warranty extends only
to the original purchaser.
Should a part become defective it should be returned to the original selling retailer
and must be accompanied with the sales receipt. If there is no retailer in your
area, call the factory for a return authorization and return your part prepaid to the
factory for inspection. PerTronix reserves the rights to replace or repair the alleged
defective part and return the part freight collect.
1-909-599-5955 • www.jbaheaders.com
Parts List:
1
Muffler, single inlet, dual outlet
1 Twin tail Pipes Assembly with JBA Chrome Tips
1 Rubber Isolator
1 3/8-16X1 1/2” Hex bolt
1 3/8 Fender Washer
1 3/8-16 Hex Nut
2 3” U Bolt Clamp
1 3” U Bolt Clamp with Hanger