Oam configuration – ADC Network Unit User Manual
Page 23
Chapter 3: Provisioning
3-5
Craft Port Configuration
Purpose:
Configure user interaction with the command line interpreter.
Command:[RW, SECURE privilege]
SET IDLE TIMEOUT <minutes>
Identifies the number of minutes that the Craft port can remain idle before a logged in user is logged off.
Command:[all privileges]
SET ECHO ON|OFF
Controls character echo for the current session.
Status Commands: [all privileges]
GET CONFIGURATION
System Name
Purpose:
Configure the system name.
Command:[RW, SECURE privilege]
SET SYSTEM NAME <name>
CLEAR SYSTEM NAME
Status Commands: [all privileges]
GET CONFIGURATION
OAM Configuration
The ENIU supports standard IEEE 802.3ah OAM operation as well as several extensions that allow its functionality
to be used across a VLAN.
Configure OAM for IEEE 802.3ah Operation
Purpose:
Configure OAM to operate as an IEEE 802.3ah device.
Command:[RW, SECURE privilege]
SET OAM CONFIGURATION
Status Commands: [all privileges]
GET CONFIGURATION
Note:
The Craft port interface has fixed communications settings of 115200 baud, 8 bits, 1 stop bit, no
parity, and no flow control.