ADC Network Unit User Manual
Page 24
Chapter 3: Provisioning
3-6
Configure OAM for EXFO Operation
Purpose:
Configure OAM to interoperate with EXFO test equipment in a VLAN environment. Note: In addition to configuring
OAM extensions, this command also changes the MAC address from which OAM messages will be accepted from
the slow protocols address to an ADC unique multicast address of 01:80:51:00:00:00.
Command:[RW, SECURE privilege]
SET EXFO OAM CONFIGURATION
Status Commands: [all privileges]
GET CONFIGURATION
Configure OAM Mode of Operation
Purpose:
Configures OAM to operate in ACTIVE or PASSIVE mode or to turn OAM processing off.
Command:[RW, SECURE privilege]
SET OAM MODE ACTIVE|PASSIVE|OFF
Status Commands: [all privileges]
GET OAM STATUS
Configure OAM Extensions
Purpose:
Configure the individual OAM extensions that allow for OAM operation over a VLAN and for use with EXFO test
equipment.
Command:[RW, SECURE privilege]
SET DISCOVERY MODE ON|OFF
Turns on abbreviated discovery mode for use with EXFO test equipment.
SET SWAP ADDRESS MODE ON|OFF
When on, forces ENIU to swap the source and destination addresses and recalculate the frame check sequence
during loopback operations so that test frames can be returned directly to the sender.
SET UNICAST MODE ON|OFF
When on, forces the ENIU to send OAM messages to the unicast address of the active mode OAM peer that is
found during OAM discovery instead of sending messages to the slow protocols address.
SET VLAN MODE ON|OFF
When on, allows the ENIU to discover VLAN tagged OAM protocol messages during OAM discovery and then use
that tag to continue OAM protocol communications.
Status Commands: [all privileges]
GET CONFIGURATION