ADC Network Unit - Manual (Page 26)

Chapter 3: Provisioning August 7, 2006
3-8 AIWN-UM-7001-01
Configure Optical Thresholds
Purpose:
On ENIUs that have optical interfaces, these commands configure the alarm thresholds associated with the power
levels of the optical connections.
Command: [RW, SECURE privilege]
SET [NETWORK|SUBSCRIBER] OPTICAL RECEIVE THRESHOLD OMA|AVERAGE threshold
SET [NETWORK|SUBSCRIBER] OPTICAL TRANSMIT THRESHOLD OMA|AVERAGE threshold
The threshold value is specified in milliwatts.
Status command: [all privileges]
GET OPTICAL THRESHOLDS
Monitor Performance
Purpose:
View and reset 15 minute and daily performance totals.
Command:[RW, SECURE privilege]
CLEAR PERFORMANCE STATUS
Status Commands: [all privileges]
GET [DAY] PERFORMANCE STATUS
The 15-minute totals are displayed unless DAY is specified. Specifying DAY will cause the daily totals to be
displayed.
Interface Status
Purpose:
View link status and alarm conditions.
Command:[all privileges]
GET INTERFACE STATUS
System Commands
Temperature
Purpose:
Shows the internal operating temperature of the system.
Command: [all privileges]
GET TEMPERATURE
Optical Power
Purpose:
On ENIUs that have optical interfaces, this command shows the level of optical power being received.
Command: [all privileges]
GET NETWORK OPTICAL POWER
GET SUBSCRIBER OPTICAL POWER