Nikon S610 - S610c - Manual (Page 34)

Configuring the Camera’s Wireless Settings
28
a
Configuring a Network Profile
Enable connection of the camera to the Internet via a wireless LAN access point. Follow
the procedures indicated below to apply the same network settings used by the
wireless LAN network to the camera. See “Configuring a Network Profile from the
Camera” (
A 29) for more information.
If your wireless LAN access point supports WPS, configuring the network profile for a
home wireless LAN access point is simple (
A 39).
B
Complimentary Wayport Subscription (the United States only)
If using complimentary Wayport subscription, a network profile has already been configured with
the camera. Be sure to proceed to “b Entering my Picturetown User Information” (
A 33) to set up
the camera’s wireless settings.
D
More on Configuring Network Profiles
Network profiles for wireless LANs can be configured ( A 29) after pictures and recipients have been
selected under the following circumstances:
• The public wireless LAN access point does not utilize the IEEE 802.1X standard.
• Home wireless LAN access points are configured as follows:
- The access point’s SSID is set to “any” (to allow connection of any wireless device).
- MAC address filtering is not enabled.
- Data is encrypted using WEP encryption, or data encryption is not enabled.
- IP addresses are acquired automatically (DHCP).
2
Choose Configure manually.
3
Choose the desired SSID (network name) or enter a new SSID.
4
Choose the desired network type.
* See “Public Wireless LAN” (
A iv) for more information on countries in which public wireless LANs
can be accessed by, and the wireless service providers that support connection of, this camera.
1
Choose Network profile from the Wireless settings option in the
camera’s setup menu.
7
Specify the camera’s IP address.
8
Enter the user name and password.
5
Choose the desired authentication method.
6
Enter the encryption key.
Home wireless LAN Public wireless LAN*