ADC H2TU-C-231 - Manual (Page 21)

LTPH-UM-1109-01, Issue 1 Provisioning
H2TU-C-231 List 2 January 9, 2002 13
P
ROVISIONING
T
ASKS
After H2TU-C-231 is successfully installed, perform these basic provisioning tasks.
• Set date and time (see “Setting Date and Time” below)
• Set circuit ID numbers (see “Setting Circuit ID Numbers” on page 14 )
• Make any necessary configuration changes (see “Configuring the System” on page 15 )
• Clear history, alarm, and event log screens to remove miscellaneous data during startup (see “Clearing the
History, Alarm, and Event Log Screens” on page 23 )
Setting Date and Time
Figure 4. Config Menu - Date and Time
1 Press to select the Config menu.
2 Use the and arrow keys to select Date and Time, then press .
3 Type the date in the format indicated, then press .
Rlogon/Rlogout Remote logon can be performed from the H2TU-C or H2TU-R. The screen displays “Rlogout”
when the H2TU-C or H2TU-R is remotely logged on to the other unit at the end of the circuit.
Remote logon from the H2TU-C will permit viewing of the H2TU-R and BERT Signal
Generator configuration submenu.
To log off from the remote unit, press . “Rlogout” changes to “Rlogon”. The unit is now
locally logged on until is pressed again to re-initiate the remote logon.
Help Provides a glossary of terms used in the maintenance screens, a list of navigational keys, and
ADC contact information.
Table 4. Logon Screen Menus (Continued)
Press this
key: To access this
menu:
Menu Functions
R
R
R
H
Monitor Performance Event Log Config Inventory Report Rlogon Help
+----------------------+
| Standard Options ->
|
| ADC Options -> |
| BERT Generator -> |
| Date and Time -> |
+-------------------------------+
| Date (mm/dd/yyyy):
05/15/2001 |
| Time (hh:mm[:ss]): 12:30:01 |
+-------------------------------+
ID: xxxx--xxxx—-xxxx--xxxx 09/01/2001 12:30:01 H2TU-C System: OK ___
C
↑ ↓ ENTER
ENTER